INNEBO
Back to products
Dimensional control

AXIA MDC

3D metrology with Digimatic gauge on the shop floor

Dimensional control system for industrial parts: 3D viewer, digital dial gauge, position sensors and barcode reader integrated in one shop-floor application.

Request demo

Problems Innex solves

Excel sheets with manual measurements: transcription errors and zero traceability.

Standalone digital gauges: the data stays on paper and never reaches the ERP.

No batch or operator audit: rebuilding an incident is impossible.

What Innex does

Interactive 3D viewer

Rotatable 3D model with per-point OK/NOK tags on the real part geometry. Each reference defines its own measuring sequence.

Multiple gauge models supported

Compatible with digital dial gauges from Mitutoyo, Mahr and other manufacturers. Auto-confirmation when a reading stays stable for 400 ms with dispersion below 0.002 mm.

Digital position sensors

The system knows the exact position of the probe and guides the operator through the sequence. No manual transcription, no confusion about which point is which.

Barcode identification

Built-in barcode reader to identify part, batch and reference in one scan. Operators never type codes by hand.

Full traceability and roles

Every reading is recorded with batch, operator, date and reference. Three differentiated roles: operator (measure), admin (configure) and distributor (license).

Real results

400ms to auto-confirm a stable reading
≤ 0.002mm of required dispersion on readings
2111work order in real production (Shaft blades)

How it works in your company

1

Identify the part

Scan the barcode on the part or batch. The system loads the matching reference with its points and tolerances automatically.

2

Check sensors and gauge

Connect the dial gauge (Mitutoyo, Mahr…) and the position sensors. Auto-detection and built-in connection test before starting.

3

Zero the gauge

Once per session, against a known zero surface. The offset is recorded for all subsequent measurements.

4

Measure sequentially

The system walks point by point, guided by the sensors. Each reading auto-confirms when stable. Instant OK/NOK on the 3D model.

5

Finish and archive

The batch is recorded with full audit. Report generated automatically, ready to print or export.

Included features

Supported hardware

  • Digital dial gauge
  • Multiple models: Mitutoyo, Mahr…
  • Digital position sensors
  • Barcode reader

Capture & processing

  • Auto-confirmation of stable readings
  • Part identification by barcode
  • Traceability by batch and operator
  • Automatic reports on close

Licensing

  • Free Demo, no expiration
  • Machine-bound license
  • Remote activation from INNEBO portal
  • Physical USB key for distributors

Who is Innex for?

Aerospace manufacturers

Dimensional control of blades, vanes and critical parts with full traceability by batch and operator.

Metrology workshops

Replace Excel sheets and isolated gauges with a system that provides full audit and automatic reports.

INNEBO distributors

Turnkey installation with a physical USB that licenses the machine, edits 3D points and adjusts the camera view at the customer site.

Want to see it in action?

A 30-minute demo on your real process.

Request demo